Wanderlust World Wanderlust World
- Replacement Drive Belt
- 1/2-Inch Socket and Ratchet
- 13 mm Socket and Ratchet
- Pliers
- Utility Knife
Step-by-Step Instructions:
1. Preparing the Tractor:
- Engage the parking brake and allow the tractor to cool down.
- Disconnect the spark plug wire to ensure the engine will not start during belt replacement.
2. Removing the Belt Cover:
- Locate the belt cover on the side of the tractor, usually held in place by 13 mm bolts.
- Use the 13 mm socket and ratchet to remove the bolts and remove the cover.
3. Releasing Belt Tension:
- Locate the belt tensioner pulley, which is usually a spring-loaded mechanism.
- Use a pry bar or pliers to push down on the tensioner pulley to relieve belt tension.
4. Removing the Old Belt:
- Use a utility knife to carefully cut through the old drive belt.
- Pull the belt off the pulleys.
5. Installing the New Belt:
- Place the new drive belt around the pulleys, ensuring proper alignment with the grooves.
- Make sure the belt is seated correctly on all the pulleys.
6. Re-Applying Belt Tension:
- Use pliers or a pry bar to push down on the tensioner pulley again, reapplying tension to the belt.
- Ensure the belt has the correct amount of tension, according to the manufacturer's recommendations.
7. Reinstalling the Belt Cover:
- Reattach the belt cover using the 13 mm bolts removed earlier.
- Tighten the bolts securely to ensure the cover is in place.
8. Reconnecting the Spark Plug Wire:
- Reattach the spark plug wire to its terminal.
9. Testing the Belt:
- Start the tractor and engage the transmission to check for proper operation of the belt.
- Observe the belt movement to ensure it is tracking correctly and not slipping.
10. Final Adjustments:
- If necessary, adjust the belt tension according to the manufacturer's recommendations to achieve optimal performance.
Remember, always refer to the specific service manual for your Ford New Holland LS55 lawn tractor for exact instructions and safety guidelines.