1. Disconnect the power source to the pump.
2. Remove the four screws that hold the pump housing together.
3. Carefully separate the pump housing into two halves.
4. Locate the impeller, which is the rotating part of the pump that moves the water.
5. Remove the two screws that hold the impeller in place.
6. Carefully remove the impeller from the pump housing.
7. Inspect the impeller for any damage or wear. If the impeller is damaged, it will need to be replaced.
8. Reassemble the pump in the reverse order of disassembly.
Here are some additional tips for removing the impeller from a Waterway Hi Flow 2hp pump:
* Be careful not to damage the impeller or the pump housing when you are removing them.
* If you are unable to remove the impeller, you may need to take the pump to a professional for servicing.
* Make sure that the impeller is properly seated in the pump housing before you reassemble the pump.
