1968 Lincoln Continental Neutral Safety Switch Location

The neutral safety switch on a 1968 Lincoln Continental with automatic transmission mounts on the top of the transmission housing, secured by two bolts, with a two-wire connector.

Access & Identification

  • Location: Driver's side of transmission, near the shift linkage attachment point.
  • Appearance: Cylindrical metal body (~2–3" diameter), bakelite/plastic base, two blade terminals.
  • Function: Prevents starter engagement unless shifter is in Park or Neutral; also activates backup lights.

Replacement Tips

  1. Disconnect battery negative terminal.
  2. Raise and support vehicle safely (jack stands).
  3. Disconnect wiring harness.
  4. Remove two mounting bolts (7/16" or 1/2" typically).
  5. Note shift linkage position before removing switch—reinstall in same orientation.
  6. Bench-test new switch with multimeter (continuity in P/N only) before install.

Common Symptoms of Failure

  • Engine cranks in gear (dangerous)
  • No crank in Park/Neutral
  • Backup lights inoperative
  • Intermittent starting

Note: Column-shift and floor-shift models use the same switch; linkage geometry differs. Verify part number (e.g., Motorcraft SW-1231 or equivalent) for your specific transmission (C6 most likely).

Copyright Wanderlust World © https://www.ynyoo.com