Choose two sturdy beams in your garage to hold the lift. Place the grid on the ground below these beams. Attach the grid together with the J hooks through the holes on each side. Hook through the grid edges. Screw it in with a washer to secure. Complete it on both sides of the grid and with both grids.
Fasten the arms to the grid according to the directions for your specific model. Secure the arms with hex screws. Install the T brackets across from the second arm.
Assemble the winding axle per the directions. Tighten it with a wrench, and secure it with the provided screws and nuts.
Slide the provided nylon cable through the winding axle on each side of the lift. Secure the gear drive with the Allen head cap screws and Allen wrench.
Assemble the winding crank and connect it to the grids per the instructions; this will vary from model to model. Test the lift to see that it works before attaching the camper shell.
