Wanderlust World Wanderlust World Grasp the water fill cap at the top rear right-hand corner and pull up to remove. Pour water into the fresh water tank. Fill until water reaches the bottom of the fill tube, being careful not to overfill. At this time, you can put in a fresh water additive according to its package instructions. Put the lid back over the fresh water tank.
Carefully read the instructions of your chemical deodorizer and determine the amount you need to use. Fully open the flush valve, located at the bottom of the potty's front. Measure the correct amount of deodorizer and pour into the bowl opening, so it flows down into the waste holding tank. Use the flush value to pump fresh water down the bowl to cover the bottom of the holding tank. Close the flush valve and move the potty around to mix the chemical and water together in the waste water tank.
Before using the potty, employ an up-and-down stroking movement to the pump to fill the bowl with fresh water.
To flush the potty after use, fully open and then close the flush value to seal the holding tank. If the bowl needs to be rinsed, run the water pump while flushing.
Monitor the waste holding level indicator periodically. This indicator can be found on the bottom left side of the potty's front. When it has a dark line reaching to the top of the indicator window, you will know that it is time to empty the waste water holding tank.
Find the one or two spring lock clips holding the fresh water and waste water compartments together and pull them out slightly. Take the waste water tank to any toilet waste disposal.
Pull out the pour spout found under the tank, remove the caps and seals from each end of the pour spout and take the sealing cap off of the holding take outlet. Attach the pour spout to the holding tank outlet and tighten the collar ring. Pull the red air vent valve up and carefully empty the tank. When finished, rinse the tank and other components that are soiled. Reassemble the potty.