Take the jewelry wire and cut a piece to fit your wrist with a little gap, leaving one, to one-and-a-half inches at the beginning and end.
Attach one end of the clasp to the wire. Using needle nose pliers for the wire, twist it around the end of the clasp to ensure it is secure. If using jewelry line secure it with two knots. Trim off the extra with scissors.
Choose the beads for your bracelet and lay them out on a towel, in the order you would like them on the bracelet. Begin threading the beads. Use half of your beads, alternating one color and then the other. Once this is done include the Lord's Prayer bead.
Finish threading the remaining beads, again, alternating colors, following the line you laid out earlier. Secure the end of your bead design with a knot and attach the clasp, trimming off any extra.
