Start your 2000 Electra Glide and let the engine get to operating temperature. Turn off the engine.
Remove the dipstick on the right side of the bike carefully, as the engine is still quite warm.
Place a drain pan underneath the Electra Glide. Remove the oil drain plug at the front of the oil pan. Drain all the oil out of the bike.
Reinstall the oil drain plug.
Remove the oil filter with an oil filter wrench. Clean the area, known as the mounting boss surface, with a shop rag.
Lubricate the rubber gasket on the new oil filter with clean motor oil. Install the new filter by hand.
Tighten the filter a half turn after the filter gasket comes in contact with the mounting boss surface.
Add 3.5 quarts of 20W-50 Harley oil into the filler hole.
Wipe off the oil dipstick and insert it into the filler hole. Check the oil level and add oil if needed.
